Used Lab Equipment

The G1311A is an optimized design ensuring virtually pulse-free and stable solvent flow with dual floating pistions.  An inlet valve electronically activated and synchronized to piston stroke eliminates vapor formation with volatile solvents and is maintenance free.  Instrument comes equipped with four solvent inlets with built-in gradient control. 

Specifications:

• Configurable Flow Range: 0.001 – 10ml/min – in 0.001ml/min increments
• Flow Range: 0.2 – 10.0 ml/min
• Recommended pH Range: 1.0 – 12.5, solvents with pH > 2.3 should not contain acids which attack stainless steel
• Gradient Formation: Low pressure quaternary mixing/gradient capability using proprietary high-speed proportioning valve. Delay volume 800-1100µl, depending on back pressure

The Agilent 1100 Series G1315 Diode Array Detector is designed for the maximum optical performance. Flexible slit setting from fine bands to highest sensitivity, with settings of 1 nm the fine structure of benzene can be revealed - even at 0.7mAUFS. A broad slit of 8 or 16nm can be chosen to minimize baseline noise thus enhancing sensitivity. System specifications include:

Specifications:

• Wavelength range: 190-950 nm
• Light source: Deuterium and tungsten lamps
• Detection type: 1024 - element photodiode array
• Short term noise (ASTM) single & mult-wavelength: ± 1° x 10-5 AU at 254 and 750 nm
• Drift: 2° x 10-3 AU / hr at 254 nm
• Linear absorbance range: > 2 AU (upper limit)
• Wavelength accuracy: ± 1 nm
• Wavelength bunching: 1 - 400 nm
• Diode width: < 1 nm
• Control and data evaluation: Agilent Chemstation for LC
• Slit width: 1, 2, 4, 8, 16 nm

Can be sold as an individual component or as part of a complete stack

Optional Column Selection Valve

Specifications:

• Temperature Range: 10° below ambient to 80° C
• Temperature Stability: ± 0.15°C
• Temperature Accuracy: ± 0.8°C
• Column Capacity: Three 30cm columns
• Warm-up/Cool Down: 5 mins from ambient to 40°C

 The 1100 HPLC G1321A Fluorescence Detector brings high-sensitivity and selection through simultaneous multi-wavelength detection. This easy-to-use detector provides quantitative data and fluorescence spectra from a single run. The FD's spectral information can be used for rapid method optimization and verification of separation quality.

Specifications:

• Dimensions: 5 x 13.5 x 17 in
• Weight:5 lbs
• Environment:0 to 40°C at <95% humidity
• Performance:10 fg Anthracene, Ex=250 nm, Em=400 nm*
• Performance:RAMAN (H2O) > 200 (FLF rev A)
• Performance:RAMAN (H2O) > 400 (FLF rev >A)
• Performance:Ex=350 nm, Em=397 nm, dark value 450 nm, standard flow cell time constant=4 seconds (8 seconds response time)
• Pulse Frequency:296Hz (single signal mode), 74Hz (spectral mode)
• Excitation Monochromator Range:200 nm - 700 nm
• Excitation Monochromator Bandwidth:20 nm
• Emission Monochromator Range:280 nm - 900 nm
• Emission Monochromator Bandwidth:20 nm
• Spectrum Acquisition Scan Speed:28 ms/datapoint
• Wavelength Characteristic Repeatability:+/- 0.2 nm
• Wavelength Characteristic Accuracy: +/- 3 nm
• Flow cells: 8 uL (standard) and 20 bar (2MPa) pressure maximum

Specifications:

• Autosampler Thermostat
• Operating temp range: 4 to 40°C (39 to 104°F)
• Operating humidity range: < 95%, non-condensing
• Maximum Power Consumption [VA]: 260 VA
• Maximum Power Consumption [W]: 210 W
• BTU: 717

Can be sold as an individual component or as part of a complete stack

Includes:

• Agilent 6890 Plus Gas Chromatograph
• 7683 100 Vial Autosampler with Injector Tower

• Agilent 5973
• Edwards RV3 Vacuum Pump
• Computer Loaded with Chemstation Software
• Monitor

Specifications:

Mass Spectrometer:  

• Mode (standard): EI
• Modes (optional): PCI, NCI EI with CI source
• Ion source type: 5 - 241.5 eV
• Ionization energy: 0 - 315 uA
• Ionization current: 100 - 350 'C
• Transfer line temperature: 150 - 300 'C
• Quadrupole temperature: 150 - 200 'C
• Mass filter: Monolithic hyperbolic quadrupole
• Mass filter protection: Entrance lens
• Mass range:6 - 800 amu
• Mass resolution: Unit mass adjustable by tune
• Mass axis stability: Better than 0.10 amu/ 48 h
• Detector: EM with replacement horn
• Dynamic range (electronic): 10e6
• Scan rate (electronic): 10,000 amu/s
• Write-to-disk: 8,000 amu/s
• SIM: 30 ions x 50 groups
• Pumping system: Turbomolecular pump
• Total flow: 2 mL/min (standard turbo)

Gas Chromatograph: 

• Automatic injector (optional): Automatic alignment, fast injection
• Liner replacement: Compatible with optional flip-top inlet sealing system
• Injector: Split-splitless (standard), others available
• Oven temperature: Ambient +4 - 450 'C
• Oven ramps / plateaus: 6-7
• Carrier gases: Helium, hydrogen, nitrogen, argon
• Electronic pnuematic control: Auto pressure regulation for split/splitless, septum purge
• Carrier gas control modes: Constant pressure and flow modes; pressure and flow programmable
• Pressure range: 0 - 100 psi (standard), 0 - 150 psi (optional) with 0.01 psi resolution, pressure and temperature corrected
• Retention-time locking:RTL ready
• Flow control: Compatible with optional microfluidics controller