Description
Load samples symmetrically. Verify that the rotor is firmly seated and the hold-down knob is hand-tight. Close the cover and set the CONCENTRATOR switch to ON. Bleeder valve operation in SpeedVac? Plus models is automatic. Aspeed sensor inside the concentrator applies vacuum when the rotor reaches 800 WM. If necessary. select DRYDIG RATE as described in section 3.3. When the run is stopped by setting the CONCENTRATOR switch to the OFF position. the unit immediately bleeds the rotor chamber. then waits 10 seconds before braking the rotor-Do not open the cover until rotation has completely stopped. Shut off chamber heater by setting DRYING RATE switch to LOW.
Specifications:
- Dimensions (W x H x D):4inx 13.Oinx 17.6in (29.0 cm x 33.0 an x 44.5 cm)
- Weight: 36 lbs (16kg)
- Electrical requirements: 120VAC / 60Hz. 6Aor240VAC/ 50Hz. 3A
- Cabinet: Chemical-resistant. coated steel construction
- Cover: Transparent 0.75 in (1.9 1 cm) acrylic (standard) Safety interlock on SCllO/SCllOA [240 V models] and SC2lOA (120 V and 240 V models) CAUTION: DO NOT apply heat to this cover – serious deformation will occur under vacuum. Optional Radiant Cover available for all units. Optional Glass Safety Cover available for SC 1 10/SC 1 10A.
- Vacuum Chamber: Chemical-resistant. impregnated alumfnum casting with inert. fluorocarbon coating.
- Vacuum Fitting:5 in (1.27 cm) O.D. vacuum fitting
- Concentrator: Two-position switch (ON/OFF)
- Drying rate: Three-position switch (HIGH/MEDIUM/LOW) (65°C/430C/Ambient)
- Drive: Seal-less magnetic coupling drive
- Rotors: Over 40 available. See section 5.0. ACCESSORIES AND ROTORS. for selection. Custom rotors available: contact Savant for details [l-800-634-8886.5 16-2494600. or (Fax) 516-249-4639].
